Unitec Wash Select II POS Installation Manual - Manual (Page 22)

W A S H S E L E C T I I
Document Number: WS21001 16
1. Locate the other end of the phone modem wire. This may have its own conduit
run, or it may run inside the optional POS4000 conduit or it may have a junction
box leading to the main PLC conduit. Once the end is found, strip back the
insulation, and crimp on another R-J11 modular plug. Ensure enough length
remains to install a service loop, or reach to a telephone jack.
Note:
If you do not have a dial tone present, verify all cable connections are correct and that
telephone service has been turned on to the site.
2. Before inserting the plug into the wall jack, use a spare or free telephone handset
to verify that the line is active. A dial tone should be heard if service is available.
Once the service has been verified, proceed to install the plug in the jack, and
secure the cable run appropriately.
4.2 Wiring for Internet Credit Clearance (Option)
If you are using Internet credit, after the CAT5 cable is installed, the IPTran modem should be
wired as follows:
Figure 9. IPTran and DataTran Connections
4.3 Wiring for WashPay Integration or Kwik Trip (Option)
If you are integrating the WashSelect II with WashPay Site Management System or are a
Kwik Trip site, the CAT5 Ethernet cable should be terminated with an RJ45 jack and run from
Document Title: Wash Select II POS Installation Manual