1 change feature name, 2 assign a postscript message to a feature – Unitec POS4000 User Manual
Page 63
P O S 4 0 0 0
Document Number:
POS4010
43
• Set Dis 1 Postscript
• Set Dis 1 Postscript
• Set Postscript All $
To execute one of the secondary commands, scroll through the secondary menu until the
command of interest is displayed, and then press the [ENTER] key.
3.8.1 Change Feature Name
To change the name (or label) of a feature, scroll through the Setup secondary menu until
"Change Wash Name" is displayed. Then press the [ENTER] key.
At this point, the top line of the display will prompt you to Enter Label Name and the second line
will display the current name of the feature. By using the alphanumeric characters on the keys,
you should type in the new name of the feature.
Warning:
If you press [ENTER] when the current name is displayed, you will change the label to
be BLANK.
Example to change the name of feature 1 (typically "PROGRAM 1") to "ECONO-WASH":
[CMD]
[FEATURE
1]
(cashier
key)
[1]
(password
1)
[MENU UP/DOWN] until "Change Wash Name" appears
[ENTER]
[E][C][O][N][O][-][W][A][S][H]
(to type [-] you must press [SHIFT] then [R] then
[SHIFT] again to return to the lower characters)
[ENTER]
Note:
The [BOLD], [CENTER] and [RED] keys have no effect on wash names.
3.8.2 Assign a Postscript Message to a Feature
The following secondary menu commands allow you to assign a postscript message to a
specific price level or to all price levels of a feature:
• Set Reg. Postscript
(Assign to Regular price only)
• Set Dis 1 Postscript
(Assign to Discount 1 only)
• Set Dis 2 Postscript
(Assign to Discount 2 only)
• Set Postscript All $
(Assign to all price levels)
Here are some examples of why you might want to assign different postscript messages to
different price levels. If you give a free wash with a gas fill up, you could print a special message
indicating that this wash is free only with a fill up. Full priced washes could have a postscript
message that indicates that the receipt can be used as a coupon for a discount on other
Document Title:
Remote Code POS4000 Installation and Operations Manual