UWater Soft Cases - Manual (Page 2)

Introduction
The Uwater 200% Waterproof Universal Soft Case sports a dual sealing system
so you can protect your personal electronics - Smartphone, Player, Camera
–
and your personal belongings - Wallet, Passport, Credit Cards, Keys - with
utmost confidence in any outdoor wet environments.
The dual (x2) sealing system comprises a lockable linear seal plus a Sliding
Security Clip.
Using Your UWater 200% Waterproof Universal Soft Case
Caution:
Product was tested at factory; however, you must test yourself prior to usage:
1.
Remove protective film from both sides of the Soft Case.
2. Insert dry paper (or towel paper) into soft case.
3. Firmly lock the linear seal using the Slide-Locker. Start from one edge,
ensure that the linear seal is completely locked.
4. Fold the top and fasten the Sliding Security Clip.
5. Submerge the soft case in water for 30 min.
6. Manipulate the soft case during submersion.
7. Remove from water and fully dry exterior.
8. Open the soft case and verify that paper is completely dry and there is
absolutely no water inside. If water is found inside the soft case,
immediately return to seller.
9. Inserting Phones: Slide in your phone all the way to bottom of the soft
case. For easier usage remove your hard case. Repeat instructions 3 and 4
above.
10. Connect rope.
Maintaining Your UWater Waterproof Universal Soft Case
Always check and test your UWater soft case before use to make sure it was not
damaged during your last activity. Do not expose it to extreme heat, such as the
inside of a hot car.
After in-water use, rinse off your UWater soft case with clean water and let it air
dry for your next use. Detergents, soaps, and chemicals must never be used to
clean this product.
For long-term storage, store out of direct sunlight.
Do not use silicone grease or any grease to lubricate this product.
2