Valco Baby Tri-mode Graco - Manual (Page 2)

for Use with graco
single/twin
car seat adaptor:
If you haven’t already done so, remove
the front bar or plugs from the nylon
housings on either side of the stroller
frame by pressing each inner ‘release
button’ and lifting the front bar or plug
from the housing.
Insert the car seat adaptor connecting
pieces into the nylon housings.
Be sure that the bar release button is
securely in the housing.
Located on the car seat adaptor
support frame are two sets of tether
straps. The first set (as shown in Figure
C) rest on the foot rest of the stroller.
Adjust these straps so they wrap
underneath the foot rest of the stroller.
Secure by inserting the male clip into
the female end.
Ensure these straps are as tight as
possible.
To secure the Twin Adaptor see Page 3
‘Secure the Twin Adaptor’.
A
C
B
The following instructions are for the Valco Baby
TriMode Models:
A
B
C
Insert the Adaptor
Secure the Adaptor
Remove Bumper Bar or Housing
Bumper Bar
Nylon Plug
press
1