Assembling / opening your bassinet – Valco Baby RAD-Bassinet User Manual
Page 2
Thank you for purchasing a quality VALCO product. Due to our policy of continuous product
development, this model is constantly evolving. It is possible that some features or procedures
outlined here have changed since this document was written. If you are unsure of any procedure
outlined here please contact the store from which you purchased it to obtain the most up to date
information, or contact us via the internet. See relevant web contact addresses on the back page.
Assembling / Opening your bassinet
Remove the bassinet from the carton and dispose of all packaging immediately and thoughtfully.
1. Lie the bassinet on a flat
surface “bottom up”
2. Swivel the two fixing arms
outward and upward till they lock
into place
1. Push out each of the wire
frames to create the bassinet
body.
2. Be sure to push each frame as
far as it can go – till the
stoppers.
1. Insert the inner liner skirt into
the bassinet making sure that
the holes fro the canopy are
correctly aligned.
2. Secure by wrapping it over the
bassinet sides.
1. Fit the mattress cover to the
mattress.
2. Insert the mattress into the
bassinet.
1. Line up each of the fixing arms
with the corresponding housing
located on either side of the
stroller frame.
2. Insert the connecters into the
housing until the seat is securely
in place.
1. Release and swivel the stability
arm downward.
© Copyright VE 2006
1. Connect and secure the stability
arm to the basket
1. To adjust your canopy,
simultaneously press the two
grey buttons on the inside of the
hood and move to the desired
position.
1. To remove your bassinet,
simultaneously press the grey
release buttons found on either
side of the bassinet.
2. Lift the bassinet out of the
frame.