Valco Baby Ion Car Seat Adaptor - Manual (Page 3)

FIGURE E
9. Place car seat in the seat portion of the stroller.
IF yOU OwN A GRACO OR PEG PEREGO
CAR sEAT
CONTINUE HERE:
FIGURE F
10. Apply pressure to the car seat until it clicks into the
adaptor.
TO BE sURE yOUR CAR sEAT Is sECURE TRy TO lIFT
THE sTROllER By THE CAR sEAT. IF yOU CAN DO THAT
wITHOUT THE CAR sEAT DETACHING, IT Is sECURE.
11. Adjust the recline on the stroller so that the car seat is
sitting in the most comfortable and secure position.
12. The car seat is now secure in your stroller.
IF yOU OwN A MAxI COsI OR CHICCO CAR
sEAT
CONTINUE HERE:
FIGURE G
10. locate a Male/Female strap attached to side of the
adaptor bar.
11. slip strap through the car seat belt hooks on the side of
the car seat.
12. Repeat with the other strap.
13. Insert Male clip into its Female counterpart and buckle
14. Adjust straps to tighten around car seat.
15. Adjust the recline on the stroller so that the car seat is
sitting in the most comfortable and secure position.
16. The car seat is now secure in your stroller.
FIGURE H
FOlDING sTROllER
1. Please remove your car seat adaptor from stroller before
folding the stroller.
NOTE: FOlDING THE sTROllER wITHOUT REMOVING THE
ADAPTOR COUlD CAUsE UNNECEssARy wEAR AND
TEAR TO THE sTROllER.
2. To remove the adaptor, reverse the steps performed in
FIGURE D by lifting lever and sliding adaptor off.
Insert car seat
click
Secure car seat
E
F
Secure car seat
G
H