Safety w arnings, Specification, Cd43 mk2 – Creek Audio CD43 mk 2 User Manual

Page 3: N o t e

Advertising
background image

3

CD43 mk2

Compact Disc Player

N O T E

The equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in residential installations. This equipment generates and can radiate radio frequency energy
and if not installed and used in accordance with the instructions may cause interference to radio
communications. However, there is no guarantee that interference will not occur in some instances. If this
product causes interference to radio or television reception, which can be determined by turning the
equipment off and on, try to correct this by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the radio or TV receiver.
Connect the equipment into a mains outlet on a circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV technician.

SAFETY W ARNINGS

Note: The specification and design
are subject to change for
improvements without notice.

OTHER FEAT U R E S

1. Infra-red remote control.
2. High precision 24 bit,

∆Σ digital to

analogue conversion.

3. 128 Fs filter.
4. 3-beam optical laser pick up.
5. 16 program memory.
6. LCD display - back lit green.
7. Shuffle function (random selection).
8. Repeat facility.
9. Intro scan facility.

CAUTION!

Invisible laser radiation

when top cover is

removed.

Class 1 Laser Product

CAUTION

PERFORMING
ADJUSTMENTS OR
PROCEDURES OTHER
THAN THOSE SPECIFIED
HERE MAY RESULT IN
HAZARDOUS EXPOSURE.

THE CD PLAYER SHOULD
NOT BE REPAIRED BY
ANYONE EXCEPT
QUALIFIED SERVICE
PERSONNEL.

SPECIFICATION

Power requirements

AC 220-240 V 50 Hz

Power Fuse rating

T 250 mA

or:

AC 110-120 V 60 Hz
T 500 mA

Power consumption

16 Watts max

Frequency response

1 Hz - 20 kHz ± 0.5 dB

Output level

2.2 V RMS at 1kHz, 0 dB

Output impedance

600

Ω ,, min load 10 k

Laser type

Semiconductor ALGaAs

Wavelength

790 nm ± 25 nm

Light output (cw)

0.18 mW typical

Signal to noise ratio

better than 96 dB

Dynamic range

better than 100 dB

Number of channels

2

Total harmonic distortion < 0.01% at 1 kHz, 0 dB
Dimensions

420 x 60 x 200 mm

Advertising