Waring WDM120 - Manual (Page 3)

4 5
The drink mixer can be operated without engaging the ON/OFF
cup actuator, by using the PULSE toggle switch. The Pulse
switch will operate at whatever speed the 3-speed switch is set to.
The PULSE switch will only operate while pressed forwards or
backward. Keep a firm grip on the cup while using PULSE .
Your Waring Drink Mixer is supplied with 2 agitators, standard
and “butterfly” (with the movable flaps). The “butterfly” agitator
should be used anytime you are mixing with a paper or styrofoam
mixing cup. Only use a standard metal mixing cup with the
standard agitator. To switch agitators, simply hold the spindle
shaft with one hand and turn the agitator in a clockwise direction.
This will loosen the screw and you can unscrew to remove. Insert
replacement agitator and screw bottom screw back in. Tighten by
turning the agitator in a counterclockwise direction.
CLEANING & SANITIZING INSTRUCTIONS
1. Rinse container thoroughly under running water. Add 8
ounces of clean rinse water to container. Place container in
normal operating position on mixer and run on high speed
for two (2) minutes. Empty container.
2. UNPLUG MIXER POWER CORD FROM ELECTRICAL
OUTLET
3. To remove bottom cup support (C), simply push up then pull
out.
4. To remove the upper cup holder (D), hold the notches on
both sides of the holder, then pull directly out from the base.
5. Wash, rinse, and sanitize the container supports, On/Off
switch actuator, and container. Sanitize these parts by
immersing in sanitizing solution for two (2) minutes. Shake
excess moisture and allow parts to air dry.
6. Working from the top down, wash, rinse, and sanitize the
portion of the mixer housing situated directly over the
container and the portion of the spindle above the agitator,
using absorbent wiping cloths moistened with cleaning
solution, rinse water and sanitizing solution.
7. Reassemble On/Off switch actuator, and container supports
to mixer housing by reversing steps 3 and 4.
8. Wash, rinse, and sanitize the bottom of the spindle and the
agitator (Illustration A and B) as follows:
Plug the Waring ® Drink Mixer cord into electrical outlet.
Add 8 ounces of washing solution to container and place in
normal operating position on mixer.
Run on high speed for a minimum of two (2) minutes.
Empty container and repeat two-minute run with 8 ounces
of water.
Empty container, and repeat two-minute run with 8 ounces
of sanitizing solution.
Empty container. Run motor for a few seconds with empty
container in normal operating position to spin off any excess
moisture. Do not rinse container, spindle or agitator after
sanitizing is completed. Allow all parts to air dry.
Wash, rinse, and sanitize as outlined above prior to initial use, and
whenever mixer will not be used again within a period of one hour
to avoid bacteria build up.
Surfaces of the mixer housing which are outside of the food
contact areas may be cleaned as required, using wiping cloths
moistened with cleaning solution, rinse water and sanitizing
solution.
UNPLUG POWER CORD FROM ELECTRICAL OUTLET BEFORE
CLEANING HOUSING. Prevent liquid from running into housing
by wringing all excess moisture from wiping cloths before using
them.
Washing solutions based on non-sudsing detergents, and
chlorine-based sanitizing solutions having a minimum chlorine
concentration of 100 PPM are recommended.