Wildview STC-TGL-5IR - Manual (Page 17)

STC-TGL5IR
www.wildviewcam.com Toll Free 888-304-6125
17
Testing the camera coverage area:
One of Wildview Scoutin
g Camera’s features is the ability to test the
coverage area.

After mounting the camera, open front housing and slide the power
switch to Test position. The front LCD will display the word “tESt”.

Close the front housing.

Walk around in the front of the camera to see if you have mounted
the camera in the proper position. A green indicator light on the
front will blink when you have intruded the coverage area.

Adjust the camera position as needed and repeat testing until the
desired coverage area is achieved.

When you have completed testing the coverage area, open the
front housing and slide the power switch from Test position to PIR
position. Front LCD counter will show “0000”. The camera will
enter count down mode for 1 minute and the front green indicator
will start blinking, giving you one minute to leave the coverage area.
Then camera will enter PIR detection mode.