Winchester Repeating Arms SX-AR (Historic Manual) - Manual (Page 18)

m ountinG o ptics
beFore Mounting a sCoPe, sight or other
aCCessories on your riFle, PlaCe the “saFety”
in the on saFe Position. reMove the MagaZine,
oPen the aCtion and MaKe Certain your riFle
is CoMPletely unloaded. KeeP the MuZZle
Pointed in a saFe direCtion. Failure to Follow
these warnings Could result in serious injury
or death.
The SX-AR is fitted with MIL-STD 1913-pattern
mounting rails on top of the receiver to attach optics.
When installing accessories, follow the manufacturers'
mounting instructions.
s tock A Djustment
beFore PerForMing stoCK adjustMent
ProCedures, PlaCe the “saFety” in the on saFe
Position. reMove the MagaZine, oPen the aCtion
and MaKe Certain your riFle is CoMPletely
unloaded. KeeP the MuZZle Pointed in a saFe
direCtion. Failure to Follow these warnings
Could result in serious injury or death.
The SX-AR includes three recoil pads of different lengths,
three combs of different heights and six shims to fine-tune
cast and drop (shim 2 is on the rifle from the factory).
These accessories allow the stock to be adjusted to fit your
style of shooting.
A DjustinG l enGth oF p ull
Three recoil pads have been included with your rifle to
allow precise length of pull adjustments (Figure 9). The
short recoil pad is 1 ⁄
2
" thick, the medium recoil pad is 3 ⁄
4
"
thick and the long recoil pad is 1" thick. The medium
recoil pad is installed on the rifle from the factory. To
install a recoil pad perform the following operation:
1. Make sure your rifle is completely unloaded and the
“safety” is in the on safe position.
16
FIGURE 9
Three recoil pads
are included.
09-056-WRA SXAR OM.indd 16 7/31/09 2:35:16 PM