Winchester Repeating Arms 94 Cross Bolt Safety (Historic Manual) - Manual (Page 18)

MANUAL HAMMER STOP IN THE "ON" POSI-
TION, AND THEN PLACE THE HAMMER INTO
THE SAFETY (REBOUND), POSITION UPON
CLOSING THE ACTION.
L OADING THE MAGAZINE —
The magazine is loaded through the port on the right side
of the receiver.
1. With the action closed and the manual hammer stop in
the “on” position and the hammer in the safety (rebound)
position, press the spring cover inward with the tip of the
first cartridge until all but the rim has entered the loading
port (See Figure 10).
2. Then, insert the next cartridge in the same manner,
pushing the preceding cartridge into the magazine.
3. Repeat this procedure with each cartridge, but push the
last cartridge past the end of the spring cover, allowing
the cover to snap closed (See Figure 11). Do not exceed
the recommended capacity of the magazine.
BEFORE LOADING, ALWAYS MAKE SURE TO
ALWAYS PLACE THE MANUAL HAMMER
STOP IN THE "ON" POSITION, AND THE
HAMMER INTO THE SAFETY (REBOUND),
POSITION.
CAUTION: ALWAYS MAKE SURE THE CAR-
TRIDGES ARE OF THE PROPER CALIBER FOR
YOUR RIFLE. CHECK THE AMMUNITION DES-
IGNATION ON THE BARREL. FAILURE TO
FOLLOW THIS INSTRUCTION CAN RESULT IN
SEVERE DAMAGE TO YOUR GUN AND POSSI-
16
FIGURE 11 FIGURE 10
Insert the cartridge
to the rim (no farther)
Push the last cartridge fully in,
allowing the cover to close
Cover closed