Allen & Heath MPS14 - Manual (Page 4)

4 MPS14 User Guide
Important Mains plug wiring instructions.
The power unit is supplied with a moulded mains plug fitted to the AC mains
power lead. Follow the instructions below if the mains plug has to be replaced.
The wires in the mains lead are coloured in accordance with the following
code:
WIRE COLOUR TERMINAL
European USA/Canada
L LIVE BROWN BLACK
N NEUTRAL BLUE WHITE
E EARTH GND GREEN & YELLOW GREEN
The wire which is coloured Green and Yellow must be connected to the
terminal in the plug which is marked with the letter E or with the Earth symbol.
This appliance must be earthed.
The wire which is coloured Blue must be connected to the terminal in the plug
which is marked with the letter N.
The wire which is coloured Brown must be connected to the terminal in the
plug which is marked with the letter L.
Ensure that these colour codes are followed carefully in the event of the plug
being changed.
Precautions
Damage :
To prevent damage to the power unit cosmetics, avoid placing heavy objects
on the unit, scratching the surface with sharp objects, or subjecting the power
unit to rough handling and vibration.
Environment :
Protect from excessive dirt, dust, heat and vibration when operating and
storing. Avoid tobacco ash, smoke, drinks spillage, and exposure to rain and
moisture. If the power unit becomes wet, switch off and remove power
immediately. Allow to dry out thoroughly before using again.
Cleaning :
Avoid the use of chemicals, abrasives or solvents. The power unit is best
cleaned with a soft brush and dry lint-free cloth. The use of electrical
lubricants is not recommended.
Transporting :
The power unit should be transported in the original packing or purpose built
flightcase to protect it from damage during transit.