CCI Thermal Technologies RCH2 - Fan-Forced Electric Open Coil Cab Heater - Manual (Page 6)

– 6 –
WARRANTY
CCI Thermal Technologies Inc. warrants to the purchaser of each new product that any part thereof which proves to be
defective in material or workmanship under normal use within 18 months of the date of shipment or 12 months from the
date of start of operation (whichever occurs first) will be repaired or replaced without charge. Any such defect should be
brought to the attention of the company's office from which the product was purchased, which is authorized to furnish or
replacement within the terms of this warranty.
The Company will not be responsible for any expenses incurred in installation, removal from service, transportation
cost, or damages of any type whatsoever, including incidental or consequential damages. Some states or provinces do
not allow exclusion or limitation of incidental or consequential damages so the preceding exclusion or limitation may not
be applicable to you.
Since we cannot anticipate or control the condition under which our products may be used, we accept no responsibility
for the safety and suitability of our products when used alone or in combination with other products. Tests for safety and
suitability of the products should be done by the user.
This warranty will not apply if, in the judgement of the Company damage or failure has resulted from accident, alteration,
misuse, abuse or operation on an incorrect power supply. The foregoing is in lieu of other warranties expressed or
implied. CCI Thermal Technologies Inc. neither assumes no authorizes any person to assume for it any other obligation,
during transportation, installation and operation or liability in connection with the said product.
Since the paint finish may be damaged in use, no warranty applies to such paint finish except for manufacturing defects
which become apparent within 30 days from date of installation.
GENERAL SPECIFICATION
Heater Model: RCH16225-01
Voltage: 208V
Power: 2000W
Phas es /Connection: 3 / wye
Heating Elem ent: Trans it duty calvane heaters
Protections : High-lim it, auto res et
Air Flow Control: Variable, 2 s peed fan
Front Cover: Alum inum
Fram e/enclos ure: Alum inum
Plug Connection: Fem ale Mate-N-Lock quick connector
Approx. Weight: 23 lbs .
Dim ens ions : 16”L x 13.5”H x 6.5”W (including handle)
Heater Drawing: C16225 Rev. 7
Surface Front Grill: 304SS, 14GA
Grille Drawing: B16252 Rev. 2