CCI Thermal Technologies BMK - Basic Mounting Kit User Manual
Installer required to supply
Basic Mounting Kit Installation Instructions
For Electric Heaters
WARNING:
If the heater is installed on a structure that is to be transported, provide additional support for the
heater during transit. The suspended weight should not exceed 250 lbs (114 kg).
Refer to the owner’s manual for mounting specifications and conditions.
Check that your heater model number corresponds to the model number shown on the mounting kit carton
.
Installer required to supply:
A method to fasten the Arm Assembly to the supporting structure. Four 3/8” diameter, grade 5
bolts are suggested, however, any method providing the same or greater strength may be used.
CONTENTS
Item Qty. Description
1 Arm Assembly
1 Mtg Attach Assy Bracket
2 Bolt, 1/2 UNC x 1-1/4”
2 Lock Washer, 1/2”
2 Nut, 1/2 UNC
1 Flat Washer, 5/8”
1 Bolt, 5/8” UNC x 1-1/4”
1 Lock Washer, 5/8”
STEP 2
Bolt Mtg Attach Assy Bracket
to the heater using 1/2
UNC x 1-1/4” bolts, lock
washers, and 1/2 UNC nuts.
Mtg Attach Assy Bracket
must be placed with the
threaded hole closest to the
control enclosure side of
heater.
STEP 1
Fasten the Arm Assembly to a surface or
structure that will support the heater’s weight
using the installer supplied fastening method.
STEP 3
Lift the heater into place and fasten
it to the Arm Assembly
using a
5/8 UNC x 1-1/4” bolt, lock washer,
and flat washer. This step will
require more than one person due
to the weight of the heater. Refer to
the owner’s manual for the weight
of the heater.
Printed in Canada. Copyright 2007. All rights reserved.
Part No. 5748-2
4”
(101mm)
19-5/16”
(490mm)
4”
(101mm)
Installer
supplied
fasteners
Heater may
be rotated as
indicated by
arrows.