Cub Cadet TRACTOR 5252 User Manual

Page 32

Advertising
background image

32

Tractors with Electric Fuse Center

Instrument Panel Fuses
The instrument panel’s circuitry is protected by the
two fuses in the fuse center. If the instrument panel
does not function properly, check the fuses.

Pull the two fuses from the fuse center and check
their condition. Replace a blown fuse with the same
capacity fuse (3 Amp). Refer to Figure 41.

Relays
The PTO relay and starter relay, located in the fuse
center, maintain power to each of those circuits. If
one of the circuits is not functioning properly, have
your dealer electrically check the relay. See Figure
40.

Figure 40

Tractors with Pedestal Mounted Relays

Electrical Circuit Relays
Several relays, which operate electrical functions of
the tractor, are located inside the lower dash panel.
If one of the circuits is not functioning properly,
have your dealer electrically check the relay. See
Figure 41.

Start Relay — Functions in the start circuit.

PTO Relay — Operates in conjunction with
both the Reverse Relay and Reverse Override
Relay to engage the PTO.

Reverse Relay — Functions with the PTO
Relay and Reverse Switch in the "No Cut in
Reverse" circuit.

Reverse Override Relay — Functions with the
Reverse Override Switch and PTO Relay to
maintain PTO engagement when driving in
reverse.

Cruise Control Relay — This relay is installed
at the factory for use with the optional Cruise
Control Kit. The relay functions in the cruise
control circuit, when the kit is installed.

Figure 41

Tractors with Hazard Lights - Flasher Relay

The flasher relay, which controls the on/off flashing
of the hazard lights, is located inside the lower dash
panel.

Replace the relay as follows:

Pull the wire harness from the right side of the
dash opening and remove the electrical tape
from the flasher relay. Refer to Figure 42.

Figure 42

Note the position of the two harness leads, then
disconnect the leads and replace the faulty
relay with a new relay. Secure the relay to the
wire harness with electrical tape.

Position the wire harness in the dash panel and
reinstall the dash panel insert.

FUSE
CENTER

PTO RELAY

INSTRUMENT
PANEL FUSES
(3 AMP)

STARTER
RELAY

Right Side

Left Side

START
RELAY

PTO

RELAY

CRUISE
CONTROL

REVERSE
OVERRIDE
RELAY

REVERSE
RELAY

RELAY
(OPTIONAL)

FLASHER
RELAY

TAPE

HARNESS
LEADS

WIRE
HARNESS

Advertising