OSRAM SYLVANIA LEDstixx Strip - Manual

LEDstixx
®
Strip
Linear LED Lighting System
INSTALLATION GUIDE
WARNING: ONLY QUALIFIED PERSONNEL SHOULD PERFORM INSTALLATION
TO AVOID ELECTRICAL SHOCK OR COMPONENT DAMAGE, DISCONNECT POWER BEFORE ATTEMPTING INSTALLATION
OF THE POWER SUPPLIES AND/OR MODULES.
Failure to install the power supplies and/or LED modules in accordance with the National Electric Code (NEC), all applicable Federal,
State and local electric codes as well as the specific Underwriters Laboratories (UL) safety standards for the installation, location and
application may cause serious personal injury, death, property damage and/or product malfunction.
These instructions are guidelines for installation of LED modules and power supplies. Installation requirements may vary depending
on the application. Licensed electricians should provide all installation services for connection for both primary and secondary
(input/output) of the power supplies.
Identification and Warnings of Safety Hazards
In accordance with ANSI Z535.4-2002 the following system of identifying the severity of the hazards associated with the products is
used:
“DANGER”: Imminently hazardous situation which, if not avoided, will result in death or serious injury.
“WARNING”: Potentially hazardous situation which, if not avoided, could result in death or serious injury.
“CAUTION”: Potentially hazardous situation which, if not avoided, may result in minor or moderate injury or property damage. Also
used to alert against unsafe practices.
IGNORING A HAZARD WILL VOID ANY WARRANTY
Caution: Product is designed for Dry Location only installations.
www.sylvania.com
The purpose of this document is to
demonstrate the LEDstixx Strip components
used to form a complete system. When
installed as instructed, this complete system
complies as a UL2108 Listed system.
LED234