OSRAM SYLVANIA LED 2x2 Retrofit Kit - Manual

SYLVANIA LED 2x2 RETROFIT KIT INSTALLATION INSTRUCTIONS
INSTALLATION SAFETY INFORMATION
Contact your local OSRAM SYLVANIA representative for any assistance needed with this installation.
REFLECTOR BRACKET
QUANTITY: 2
DIFFUSER LENS ASSEMBLY
QUANTITY: 1
BLUE WIRE NUT
QUANTITY: 5
LIGHT ENGINE PANEL
QUANTITY: 1
ORANGE WIRE NUT
QUANTITY: 2
END BRACKET
QUANTITY: 2
DRIVER QUICK
DISCONNECT
QUANTITY: 1
SYLVANIA LED DRIVER
QUANTITY: 4
LED RETROFIT KIT EXPLODED VIEW
#8-32 1/2”
HEX HEAD
SELF DRILLING SCREW
QUANTITY: 3
#8-32 3/8”
SLOTTED HEX HEAD
SELF THREADING SCREW
QUANTITY: 7
LED262 1/2012
PUSH FASTENER
QUANTITY: 2
LED SUB ASSEMBLY
SAFETY TETHER
QUANTITY: 2
12” 18 GA GREEN
GOUND STRAP
QUANTITY: 2
WARNING—Risk of fire or electric shock. Luminaires wiring, ballasts, or other electrical parts may be damaged when drilling for installation of
reflector kit hardware. Check for enclosed wiring and components.
WARNING—Risk of fire or electric shock. LED Retrofit Kit installation requires knowledge of fluorescent lighting luminaires electrical systems. If
not qualified, do not attempt installation. Contact a qualified electrician.
WARNING—Risk of fire or electric shock. Install this kit only in the luminaires that has the construction features and dimensions shown in the
enclosed photographs and/or drawings.
WARNING—To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
WARNING—Do not make or alter any open holes in an enclosure of wiring or electrical components during kit installation.
INSTALLATION OF THIS LED RETROFIT KIT ASSEMBLY REQUIRES A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF LOW
VOLTAGE LUMINAIRE ELECTRICAL SYSTEMS AND THE HAZARD INVOLVED.
The SYLVANIA LED 2x2 Retrofit Kit uses self-drilling hardware for ground straps and power supply installation. Check for electrical wiring and
components above luminaire housing prior to installation to avoid damage to A/C, sprinkler or other electrical systems.