Hookup, Aiming the antenna, Xm reception – Crestron electronic Antenna System SRD-ANT-1LD-PAK User Manual

Page 9: Crestron srd-ant-1ld-pak antenna system

Advertising
background image

Crestron SRD-ANT-1LD-PAK Antenna

System









Mounting Hardware

Wall Mount

Bracket

Saddle

U-Bolt

2” DirecTV Pole

1 ¾” Dish Network Pole

Hookup

After the antenna is mounted, refer to the diagram on page 1, connect cables, attach
the in-line amplifier(s), adjust the antenna position, and finalize the installation as
follows:

1. Attach the in-line amplifier to the antenna using a short RG-6 cable (not

supplied), providing a strain relief for the cable. Ensure the amplifier is
oriented with the Ant end toward the antenna and the Radio end toward the
radio.

NOTE: For best results in all configurations, use quad-shielded RG-6 cable
whenever possible.

2. Connect an RG-6 cable not longer than 350 feet with male F-connectors to

the in-line amplifier Radio end.

3. Using the supplied 3-foot F-Female to SMB adapter cable, connect the

RG-6 cable from the antenna to the radio’s antenna input.

4. Adjust the azimuth and elevation pointing of the antenna for best reception

using the antenna signal strength menu in the radio. The antenna has a beam
width of ± 25º, which is narrower than standard consumer-quality home-kit
antennas, but provides higher gain and rejection to multi-path interference.

The “Appendix”, which starts on page 8, lists exact magnetic azimuth
bearings and elevation pointing angles for many major cities throughout the
US and Canada.

5. Tighten all hardware and seal the outdoor connectors using the included

weather boot or other means to prevent moisture ingress.

Aiming the Antenna

Refer to the documentation supplied with the tuner/radio for information on
observing signal strength. Adjust the antenna as required to maximize the signal.

XM Reception

XM has two satellites located in fixed orbital positions in the southern sky (at 115°
W longitude and 85º W longitude). These satellites each carry all of the XM
channels, so it is only required to have an un-obscured line-of-sight to one of these
orbital locations.

Installation Guide – DOC. 6722A

Antenna System: SRD-ANT-1LD-PAK

5

Advertising