LaMotte CDS 5000 Conductivity Meter User Manual
Page 14
Advertising
MAINTAINING THE METER
REPLACING THE BATTERY
When “BAT” appears on the display, the battery should be replaced. The
temperature reading will be the first function to be affected by a low
battery.
1. Use a #1 Phillips head screwdriver to remove four screws on the back
of the meter case.
2. Gently lift back panel from meter.
3. Lift battery from bottom of meter. Remove from connector.
4. Snap new battery onto connector.
NOTE: The CDS 5000 uses a type 1604A (9 volt) battery.
5. Lower battery into compartment. Replace back panel and screws.
AC ADAPTER
An AC adapter is available for use with the CDS 5000. Order as code
#1708. Insert connector into small hole next to the probe connector.
CLEANING THE PROBE
Adjust This
Potentiometer
Advertising