LaMotte SALINITY TEST KIT POL-H - Manual

SA LIN ITY TEST KIT
MODEL POL-H • CODE 7459-01
QUANTITY CONTENTS CODE
15 mL *Salinity Indicator Reagent A *7460-E
2 x 30 mL *Salinity Titration Reagent B *7461DR-G
1 Demineralizer Bottle 1151
1 Test Tube, 5-10-15 mL, w/cap 0778
1 Direct Reading Titrator, 0-20 Range 0378
1 Direct Reading Titrator, 0-1.0 Range 0376
*WARNING: Reagents marked with an * are considered to be potential health
hazards. To view or print a Material Safety Data Sheet (MSDS) for these reagents go to
www.lamotte.com. To obtain a printed copy, contact LaMotte by e-mail, phone or fax.
To order individual reagents or test kit components, use the specified code number.
Read Demineralizer Bottle instructions before proceeding.
NOTE: The Demineralizer Bottle may not remove all of the chloride ions
from tap water. Tap water from water softener systems may contain
abnormally high amounts of chloride. This may result in high salinity test
results. Perform a salinity test on the Demineralizer Bottle water ONLY to
determine the contribution by the tap water to the salinity test result.
PRO CE DURE
0-20 ppt SALINITY
1.
Fill test tube (0778) to 10 mL line with demineralized water from the
Demineralizer Bottle (1151).
2. Fill the 0 - 1.0 Direct Reading Titrator (0376) to 0 line with sample
water. Wipe any excess water off the Titrator.
3. Dispense 0.5 mL of sample water into titration tube by depressing
plunger until tip is at 0.5 line. Discard remaining water in Titrator.
4. Add 3 drops of *Salinity Indicator Reagent A (7460). Cap and gently
swirl to mix. Solution will turn yellow.
5.
WARNING! This set contains chemicals
that may be harmful if misused. Read
cautions on individual containers
carefully. Not to be used by children
except under adult supervision