Coda V10 - Manual (Page 8)

BRIDGED operation consists of one, or both sets of AMPLIFIER v10 channels. The amount
of power from a four channel AMPLIFIER v10 is 100 Watts with 8 Watts class A per channel.
A bridged AMPLIFIER v10 has 400 Watts with 8 Watts class A per set of channels. To bridge,
set the MODE switch on the back of the amplifier to the BRIDGED position.
NOTE: TURN THE MAIN AC POWER
SWITCH ON THE BACK OF THE
AMPLIFIER v10 OFF BEFORE
ALTERING THE MODE SWITCH
OR CONNECTING OR
DISCONNECTING ANY CABLES.
The bridging switch commons the inputs of the AMPLIFIER v10, were pin 2 of the left XLR
commons with pin 3 of the right XLR, and pin 2 of the right XLR commons with pin 3 of the
left XLR.
The set up diagram for BRIDGED operation is on the following page.
DETAILED INSTALLATION 7
III. BRIDGED SETUP
WARNING: DO NOT OPERATE THIS AMPLIFIER WITH THE TOP COVER REMOVED. NEVER MAKE
ANY INTERNAL ADJUSTMENTS WHILE THIS AMPLIFIER IS CONNECTED TO AN AC POWER SOURCE.
BRIDGED
STEREO
MODEL
SERIAL NUMBER
MODE
Back of AMPLIFIER v10