Maintenance – Chicago Electric CAMARILLO 93255 User Manual

Page 6

Advertising
background image

SKU 93255

For technical questions, please call 1-800-444-3353

.

Page 6

Maintenance

1.

Store in a clean and dry location.

2.

Charge the Battery after each use, and every three months if not used.

3.

If the 12 VDC cord does not function, the fuse may be blown. Unscrew the

metal nut at one end of the cord and remove the old fuse. If the wire inside is
broken, replace with another F10A250V (Fast-acting, 10 Amp, 250 Volt) fuse
of the same type.

Battery Replacement

1.

Remove the screws at the top back of the spotlight and open the Hatch (26).

2.

Carefully pull out the existing Battery and pull off the wire terminals.

3.

Replace the Battery with a new one of the same type (See page 2).

4.

Push the red wire connector onto the positive (+) Battery terminal and the

black wire connector onto the negative (–) Battery terminal. Be sure that the
wires are connected properly.
Otherwise, the Spotlight will be damaged.

5.

Place Battery back into the battery compartment. Close the Back Cover, and

install and tighten screws.

6.

Charge the new Battery as described on page 4.

Bulb Replacement

Note: Make sure all parts are cool to the touch before

replacing the bulb.

1.

Pull the Lens Ring Cover (1) off and set it aside.

Un-thread the Lens Holding Ring (2), being careful
not to allow the Lens (3) to fall out.

2.

Be careful - the edges of the Lens may be sharp!

Remove Lens and

gently

set it aside, it is fragile.

3.

Remove the Refractor (4) and detach the three

wires leading to the Bulb (5).

4.

Squeeze the ends of the Bulb Retaining Spring

(6) together, and hold them - see A, right.

5.

Swing the Bulb Retaining Spring (6) up and remove

it - see B, right.

6.

Turn the Bulb (5) slightly counterclockwise and

slide it out - see C, right.

7.

Using a clean rag, cloth or gloved hand, install a

proper replacement Bulb without touching the bulb
portion. If the bulb is touched, it must be cleaned with rubbing alcohol and
allowed to dry before being installed.

(Bulb replacement continued on next page.)

Advertising
This manual is related to the following products: