Cool Embedded PCs Automotive PC Enclosure - Manual (Page 4)

http://www.cartft.com, Cool Embedded PCs
Figure 1.0, bottom mounting plate
3.0 VoomPC-2 installation steps
1) Install the motherboard, Front Audio / USB board and Power Supply on the base plate
using M3 screws. (See figure 1.0)
2) Connect the ATX cable harness provided with your power supply to the motherboard.
NOTE: Use small tie-wraps on the ATX cable harness in order to improve air flow.
3) Connect the Front Audio header (marked “AUDIO”) to the motherboard’s Front Audio
header using the 2x5 shielded cable. NOTE: You need to remove the 2 jumpers from the
Motherboard’s Front Audio header.
4) Connect the Front USB header (marked “USB”) to the motherboard’s internal USB
header.
5) Connect the LED header to the Motherboard’s LED header. If using M1-ATX or M2-
ATX power supplies you might want to connect this LED to the power supply LED
header. (The M1/M2-ATX provides additional visual information (blinks) reporting various
states of the system)
6) Connect the Fan-In header to the motherboard’s fan header. Connect the Fan1 and
Fan2 headers to the front fans.
VoomPC-2 Installation Guide Page 4