Programming, To control the opener lights, Button remotes – Chamberlain POWERDRIVE PD610D User Manual

Page 27

Advertising
background image

KG

1

3

9

7

5

KG

1

3

9

7

5

27

1. Press and release the “learn” button on

the motor unit. The learn indicator light
will glow steadily for 30 seconds.

2. Within 30 seconds, press and hold the

button on the hand-held remote* that
you wish to operate your garage door.

3. Release the button when the motor

unit lights blink. It has learned the
code. If light bulbs are not installed,
two clicks will be heard.

NOTICE: If this Security

®

garage door opener is operated with a non-rolling code transmitter, the technical measure in

the receiver of the garage door opener, which provides security against code-theft devices, will be circumvented. The
owner of the copyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code
transmitter to circumvent that technical measure.

Your garage door opener has already been programmed at the factory to operate with your hand-held remote control.
The door will open and close when you press the push button.

Below are instructions for programming your opener to operate with additional Security

®

remote controls.

Using the “Learn” Button

Using the Multi-Function Door Control

LOCK

LIGHT

LOCK

LIGHT

1. Press and hold the button on the

hand-held remote* that you wish to
operate your garage door.

2. While holding the remote button, press

and hold the light button on the
Multi-Function Door Control.

3. Continue holding both buttons while you

press the push bar on the Multi-Function
Door Control (all three buttons are held).

4. Release buttons when the motor unit

lights blink. It has learned the code. If
light bulbs are not installed, two clicks
will be heard.

Only available with Multi-Function Door Control:

In addition to operating the door, you may
program the remote to operate the lights.

1. With the door closed, press and hold a

small remote button that you want to control
the light.

2. Press and hold the Light button on the Multi-Function

door control.

3. While holding the Light button, press and hold the Lock

button on the door control.

4. After the opener lights flash, release all buttons.

If provided with your garage door opener, the large
button is factory programmed to operate it. Additional
buttons on any Security

®

multi-function remote or
mini-remote can be
programmed to operate
other Security

®

garage door opener

s

.

TO ADD OR REPROGRAM AN ADDITIONAL HAND-HELD REMOTE CONTROL

PROGRAMMING

TO CONTROL THE OPENER LIGHTS

*3-BUTTON REMOTES

LOCK

LIGHT

Advertising