Chamberlain POWERDRIVE PD610D - Manual (Page 28)

28
1. Press and release the “learn” button
on motor unit. The learn indicator light
will glow steadily for 30 seconds.
2. Within 30 seconds, enter a four digit
personal identification number (PIN) of
your choice on the keypad. Then press
and hold the enter button.
3. Release the button when the motor
unit lights blink. It has learned the
code. If light bulbs are not installed,
two clicks will be heard.
NOTE: Your new Keyless Entry must be programmed to operate your garage door opener.
Using the “Learn” Button Using the Multi-Function Door Control
LOCK LIGHT
NOTE: This method requires two people if the Keyless
Entry is already mounted outside the garage.
1. Enter a four digit personal identification
number (PIN) of your choice on the
keypad. Then press and hold enter.
2. While holding the ENTER button, press
and hold the LIGHT button on the
Multi-Function Door Control.
3. Continue holding the ENTER and LIGHT
buttons while you press the push bar on
the Multi-Function Door Control (all three
buttons are held).
4. Release buttons when the motor unit
lights blink. It has learned the code. If
light bulbs are not installed, two clicks
will be heard.
LOCK LIGHT
LOCK LIGHT
TO ADD, REPROGRAM OR CHANGE A KEYLESS ENTRY PIN
TO CHANGE AN EXISTING, KNOWN PIN
If the existing PIN is known, it may be changed by one
person without using a ladder.
1. Press the four buttons for the present PIN, then press
and hold the # button.
The opener light will blink twice. Release the # button.
2. Press the new 4-digit PIN you have chosen, then
press Enter.
The motor unit lights will blink once when the PIN has
been learned.
Test by pressing the new PIN, then press Enter. The door
should move.
ENTER
QZ
0
TUV 8 PRS 7 WXY 9
5 4 6