SARGENT 8200 Lever Mortise Locksets - Manual

INSTALLATION INSTRUCTIONS
Trim Mounting Kit on 8200 Lever Mortise Locksets
FOR INSTALLATION ASSISTANCE CALL SARGENT AT 1-800-727-5477 • www.sargentlock.com
Copyright © 2009, Sargent Manufacturing Company,
an ASSA ABLOY Group company. All rights reserved.
Reproduction in whole or in part without the express written
permission of Sargent Manufacturing Company is prohibited.
A5759B
STANDARD 8200 MORTISE LOCKSET SHOWN PARTS LIST DESCRIPTION
A.) Inside Trim Pack consisting of:
1. Lever set screws (2) [1 long, 1 short]
2. Lever Adapter
3. Machine screws #8-32 x 5/8” (2)
4. Adapter and plate assembly (2)
5. Washers (2)
6. Cap Nut
7. Spindles (2)
NOTE: Items 2, 4, 5 and 6 are pre-assembled
when shipped.
B.) Outside Trim Pack consisting of:
8. Cap Nut
9. Washers (2)
10. Adapter and plate assembly
11. Mounting Posts (2)
12. Spindle Springs (2)
C.) Complete trim pack consisting of:
Both inside trim pack (A) and outside
trim pack (B) together
2.175
1.482
.040 x45 ∞ Angle
Ø.558 Dia.
Ø.625 Dia.
.187
.067
.268
5/8-18UNF-2A Thread
.3155 SQUARE
.3135
.4375 MIN ACROSS CORNERS
.007 MAX Radius
.4375 MIN ACROSS CORNERS
.3155 SQUARE
.3135
4 CORNERS 4 CORNERS
.007 MAX Radius
.075
.236
.435
.960
1.735
Ø.3445 Dia. BRASS/BRONZE
Ø.372 Dia. MAX STAINLESS Ø.3445 Dia. BRASS/BRONZE
Ø.372 Dia. MAX STAINLESS
Ø.564 Dia.
Ø.757 Dia.
1/4-28 UNF-2B Thread
Ø.990 MIN Dia. Ø.990 MIN Dia.
OUTSIDE LEVER
WHEN BY OTHERS INSIDE LEVER
WHEN BY OTHERS
Inside Lever Requirements/Specifications: Outside Lever Requirements/Specifications:
IMPORTANT NOTE: UNLESS OTHERWISE SPECIFIED ALL TOLERANCE TO BE + OR - .005
LEVER WEIGHT AND CONFIGURATION (center of gravity - cg) MUST NOT APPLY A MAXIMUM LEVER
TORQUE THAT EXCEEDS 1.4 in-lbs.
2
12*
3
4
6
7
5
9
10
11
1
Shape of this mounting plate
will vary depending on the
trim design used
Shape of this mounting plate
will vary depending on the
trim design used
12*
7
8
IF USING NON SARGENT LEVERS THEY MUST BE MANUFACTURED TO MEET THE
FOLLOWING SPECIFICATIONS
Please Note: Refer to the fol-
lowing instruction sheets for
complete lock installation.
· LN or L Trim - A7035
· LE or LW Trim - A7031
· LS Trim - A7029
· WT Trim - A7034
* Insert (2) springs, large end first, into spindle hole in levers.