7800pt multi function lock instructions, How to change hand of lock – SARGENT 7800 Mortise Lock with Push/Pull Trim (PT) User Manual
Page 4
4
Copyright © 2011, Sargent Manufacturing Company, an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the express written
permission of Sargent Manufacturing Company is prohibited.
A8130C
7800PT MULTI fUNCTION LOCK INSTRUCTIONS
How to Change function of Lock:
Green catch screw must be located as designated on lock case to create desired function.
3 locations: One for 05, 37 & 38 functions (15 function in unlocked position)
One for 04, 06, 13, 17 & 31 functions
And one for 36 function
Note: When moving green catch screw to 04, 06, 13, 17 & 31 functions, hub
position must be at 45° as shown on lockcase.
Note: 17 function requires both levers to be rigid. Rotate red locking piece 90°,
so red surface of slide faces back of lockbody.
7800PT lockbody is required when using PT paddle trim, 8200 lever lockbody
will not function properly with the PT trim.
36
05
37
38
04 06 13 17 31
CHECK HUB
HUB
Items needed to create each of the following functions:
function Outside
Lever
Inside
Lever
Trim One
Side Kit
Outside
Cylinder
Inside
Cylinder
Thumb
Turn
04
X
X
X
05
X
X
X
X***
06
X
X
X
13
X
X
17
X
X
X
X
31
X
X
X
36
X
X
X
37
X
X
X
38
X
X
X
X
#41 Cylinder is standard for both single & double cylinder
functions for 1-3/4" thick door
NOTE: Trim-one-side functions always require an
inside trim assembly which can be used on the inside
or outside of the door
U.S. Patent (Pending) No. 5,678,870
How To Change Hand of Lock
INSIDE
INSIDE
OUTSIDE
OUTSIDE
LEFT HAND
LEFT HAND
REVERSE
BEVEL
RIGHT HAND
RIGHT HAND
REVERSE
BEVEL
DOOR HANDS DETERMINED FROM OUTSIDE
DOOR HANDING
Note: Beveled surface of latch must face strike. The deadlatch
is self adjusting. To change hand of latch:
Note: Red surface of locking piece must face secure
(keyed/locked) side of door.
To rotate locking piece:
1. Position lockbody with red surface of locking piece visible.
2. Insert blade type screwdriver into locking piece slot to rotate
locking piece.
3. Push locking piece toward back of lock body and rotate 180°
until RED surface shows on opposite side.
Red color
indicates locked
side of door or
hold back side
(91 and 92
Functions)
Locking
piece
slot
1. Insert screwdriver blade into
the spade shaped slot
2. Rotate screwdriver 90º to push latch out until back of latch
clears lock front. Then rotate latch 180º. Latch will then re-enter
lockbody. (Note: Latch can not be unscrewed)
IMPORTANT: 04, 06, 13, 17 and 31 functions require:
(a) Green catch screw
to be removed
(b) Rotate hub 45°
to vertical position
(c) Rotate locking piece
for required hand
(d) Red surface faces
locked side of door
(e) Rotate hub to the
original 45° position
as shown on lockcase
(f) Green catch screw is
then reinstalled