ClearOne PANVP700 - Manual

NS-0106-7149, Addendum 1
All specifications subject to change without notification. All rights reserved. Copyright © 2006 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 78727 / www.netstreams.com.
Addendum
PAN6400 Installation Guide
Panorama PANVP700 Video Port
The PANVP700 Video Port provides a way of connecting to a video display from a source connected to the Panorama
PAN6400 Video Distribution Center (VDC) The PANVP700 also features an IR receiver input and ships with an IR receiver.
If you have the source remote, you can control the source from any room that has a PANVP700 connected to that source. The
PANVP700 is designed for installations using the PAN6400 as a standalone device or a PAN6400 that is controlled by a third-
party controller using RS-232.
NOTE: The PAN6400 IR receiver is disabled if the PAN6400 is connected to a Musica™ system. Musica keypads already
provide this functionality.
NOTE: Use standard, unshielded CAT5e cable for wiring between the PAN6400 and the PANVP700 and terminate it using
the 568a standard.
The PANVP700 ships with:
 a NetStreams IR receiver,
 wall plate,
 five Cable Length Compensation (CLC) cards (in 50-, 250-, 500-, 750-, and 1000-ft increments).
NOTE: The PANVP700 comes with the 250-ft CLC card already inserted into the CLC slot on the back panel.
Panels
Figure 1 shows the front and back panels of a PANVP700.
Figure 1 PANVP700 front and back panels.
Front Panel Back Panel Front Panel