ClearOne GT1524 - Manual (Page 39)

35 Appendix E ~ Compliance
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
USOC Jacks: This device uses RJ11C and RJ21X terminal jacks.
The REN is used to determine the quantity of devices which may be connected
to the telephone line. Excessive RENs on the telephone line may result in the
devices not ringing in response to an incoming call. In most, but not all areas, the
sum of the RENs should not exceed five (5). To be certain of the number of devices
that may be connected to the line, as determined by the total RENs, contact the
telephone company to obtain the maximum RENs for the calling area.
If this equipment causes harm to the telephone network, the telephone
company will notify you in advance that temporary discontinuance of service may
be required. If advance notice is not practical, the telephone company will notify
the customer as soon as possible. Also, you will be advised of your right to file a
complaint with the FCC if you believe it is necessary. The telephone company may
make changes in its facilities, equipment, operations, or procedures that could
affect the operation of the equipment. If this happens, the telephone company will
provide advance notice for you to make the necessary modifications in order to
maintain uninterrupted service.
If you experience problems with this equipment, contact ClearOne
Communications, Inc., 1825 Research Way, Salt Lake City, Utah 84119, or by
phone at (801) 874-3760 for repair and warranty information. If the trouble is
causing harm to the telephone network, the telephone company may request you
remove the equipment from the network until the problem is resolved.
Industry Canada compliance
The Industry of Canada label identifies certified equipment. This certification means
that the equipment meets certain telecommunications network protective operational
and safety requirements. The Department does not guarantee the equipment will
operate to the user’s satisfaction.
Before installing this equipment, users should ensure that it is permissible to
be connected to the facilities of the local telecommunications company. The
equipment must also be installed using an acceptable method of connection. In
some cases, the company’s inside wiring associated with a single line individual
service may be extended by means of a certified connector assembly (telephone
extension cord). The customer should be aware that compliance with the above
conditions may not prevent degradation of service in some situations.
Repairs to certified equipment should be made by an authorized Canadian
maintenance facility designated by ClearOne Communications. Any repairs or
alterations made by the user to this equipment, or equipment malfunctions, may