ClearOne MAX EX/MAXAttach - Manual (Page 7)

Chapter 1: Introduction 3
This product should be operated only from the type of power source indicated on the marking label. If you
are not sure of the type of power supply in your location, consult your dealer or local power company.
Do not overload wall outlets and extension cords as this can result in the risk of fire or electric shock.
Never push objects of any kind into this product through cabinet slots as they may touch dangerous voltage
points or short out parts that could result in fire or electric shock.
Never spill liquids on the product.
To reduce the risk of electric shock, do not disassemble this product. Opening or removing covers may
expose you to dangerous voltages or other risks. Incorrect reassembly can cause electric shock during
subsequent use.
Unplug this product from the wall outlet and battery source and refer servicing to qualified service personnel
under the following conditions:
When the power supply cord or plug is damaged or frayed.
If liquid has been spilled into the product.
If the product does not operate normally according to the operating instructions.
If the product has been dropped or damaged.
If the product exhibits a distinct change in performance.
Do not use this product or other phones during an electrical storm. There is a remote risk of electric shock
from lightning.
Do not use this product to report a gas leak in the vicinity of the leak.
Do not use this product near intensive care medical equipment or by persons with pacemakers.
Due to the radio signals between base station and POD, wearers of hearing aids may experience interference
in the form of a humming noise.
This product can interfere with electrical equipment such as answering machines, TV sets, radios, computers
and microwave ovens if placed too close.
Telephone Wiring and Jack Information
To reduce the risk of fire or injury to persons, read and follow these instructions:
Use caution when installing or modifying telephone lines.
Never install telephone wiring during an electrical storm.
Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.
Never touch un-insulated telephone wires or terminals unless the telephone line is disconnected at the
network interface.
Save These Instructions
•
•
•
•
•
•
»
»
»
»
»
•
•
•
•
•
•
•
•
•