ClearOne MAX IP Conferencing Phone - Manual (Page 7)

4 Technical support: 800.283.5936
Using the Phone in a Three-Way Call
Press the 1. HOLd key to place both lines on hold.
Press the 2. ON/OFF key to hang up both lines.
> Note: The Leds flash red when a call is on hold.
Press the HOLd key a second time to take both lines off hold and resume three-way conference call.
If either of the other parties hangs up during the three-way call, the remaining party stays connected to the call.
3.
To Make an Outbound Call While on Another Call
Press the 1. HOLd key and then press the ON/OFF key. The first party is put on hold and you are connected to a
second line dial tone.
dial the second party’s phone number.
2.
> Note: stored numbers are not available for dialing a second party.
If you receive a busy signal or are routed to voicemail, then press the ON/OFF key to terminate the call and
return to the first party.
Press the
3. HOLd key to toggle between the first and second parties or press the CONFErENCE key to join the two
parties in a three-way conference call.
> Note: see TO MAKE AN OUTBOUNd THrEE-WAY CALL for more information.
To Accept an Inbound Call While on Another Call
The phone rings (unless the ringer is muted) and the Leds flash green. 1.
Press the 2. HOLd key and then press the ON/OFF key. The first party is put on hold and you are connected to the
incoming call.
> Note: If you want to disconnect the incoming call after answering it, press the ON/OFF key to hang up
the second call and then press the HOLd key to take the first party off of hold.
Press the 3. HOLd key to toggle between the first and second parties or press the CONFErENCE key to join the two
parties in a three-way conference call.
> Note: see TO MAKE AN OUTBOUNd THrEE-WAY CALL for more information.
toneS and aLertS
Figure 6 - MAX IP Tones and Alerts
Tone/Alert Description
Confirmation
Reject
A tone will play upon successful programming entry.
A tone will play if you attempt to do any of the following:
• enter an invalid programming entry
• use a speed dial key that has not been programmed
(One-Touch Conferencing or service center)
• enter a 45th digit when predialing
• enter a 17th digit for user phone number
• enter a 31st digit for speed dial key (One-Touch
Conferencing or service center)