ClearOne MAX EX - Manual (Page 2)

USINg ThE PhONE
To Make a Call
1. Press the ON/OFF key to activate the
phone. You will hear a dial tone.
2. Dial the number as you would on a
standard phone. The number appears on
the LCD screen.
You can also predial the number while in
Standby mode and press the ON/OFF
key to connect the call.
To add a pause to the number you are
predialing, press and hold the pound (#)
key.
To Answer a Call
• Press any key (except the“*”, MUTE,
VOLUME UP or VOLUME DOWN keys).
When there is an incoming call, the phone
rings (unless the ringer is turned off) and
the phone LEDs and phone icon on the
LCD screen flash.
To End a Call
• Press the ON/OFF key.
To Turn the Ringer On/Off
(In Standby)
• Press and hold the "*" key until the ringer
off icon appears on the LCD display.
To Adjust Ringer Volume
• While the phone is ringing, press
VOLUME UP or VOLUME DOWN.
• While the phone is inactive, press
VOLUME UP or VOLUME DOWN. The
ringer melody will play once at the new
level.
To Access a Speed Dial Number
• Press the SPEED DIAL key. This
feature must be programmed before use.
To Access Your Service Center
• While in Standby mode, press and hold
the 0 key for 2 seconds. This feature must
be programmed before use.
To Store a Number in the Phonebook
1. Enter the number while phone is in
standby (inactive) mode.
2. Press and hold the PhONEBOOK key
until the Phonebook and Program icons
appear.
3. Assign a Phonebook location (0–9)
by pressing the corresponding number
key.
4. Press PhONEBOOK again to save the
entry. You will hear a confirmation tone.
5. To exit Phonebook Edit mode before
saving the entry, press CLEAR.
To Make a Call Using the Phonebook
1. Press the PhONEBOOK key.
2. Press the number (0-9) key that
corresponds with the stored phone
number you want to dial. The number will
be displayed on the LCD screen.
3. Press the ON/OFF key to dial the number.
KEYPAD FUNCTIONS
LCD DISPLAY
Phonebook and Program icons
The Phonebook and Program icons.
Ringer off icon.
Phone active icon