Dymo 1000Plus User Manual
Page 3
4
A A
Normal
text
Underlined
Box
around
Shaded box
around
COPIES
SYM
v
e
r
t
i
c
a
l
l
y
This is a two
line label
• Press
+
or
to move the
cursor to the beginning or end of the text.
• When used in conjunction with certain function
keys, use
or
to select options.
• To insert characters into the text, use
or
to position the cursor under the
character to the right of the insertion point,
then type in the characters required.
PRINTING
• Press
to print the label.
• Use cutter lever E
➊
to release and tab-cut the
label – see page 2.
SPACE KEY
• Press
to insert a space into the text.
FEED KEY
FEED
• Press
+
FEED
to feed out 20mm of
blank tape
SYMBOLS
• Press to select a symbol character – see
‘Symbols and special characters’ and the
symbols table on page 2.
TEXT SIZE
SIZE
• Press to display the six text print sizes:
half-height, condensed full height, condensed
half-height, normal full height, normal
half-height, extended full height, extended
The cursor will be positioned over the current
selection.
• Either press
DEL
to exit, or use
or
to move the cursor over the size symbol
required, then press
SIZE
to confirm the
selection, or
to confirm the selection
and print the label.
VERTICAL TEXT
+
VERT
/
-
• Rotates the text through 90° so that the label is
printed , as confirmed
by the
VERT
indicator, top right of the display.
• Press again to cancel and return to horizontal
text.
Note: Vertical text is not available on two-lines.
2-LINE PRINTING
• Press
to start the second line of text on a
two-line label. The two lines will be printed
half-height and ranged left, e.g.
This is a two
line label
in the display
will be printed as:
BOXED/UNDERLINED PRINTING
/
-
• Press
/
-
once to display the menu above.
• Use or to move the cursor under
the desired option and press
to enter.
(confirmed by the or indicator displayed.
• To exit this menu and return to normal text
press
DEL
.
ITALIC
ITALIC
• Press once to print the label in
italic
text
(confirmed by the
ITALIC
indicator in the
display).
Press again to cancel and return to normal
text.
OUTLINE +
• Press shift followed by outline to print the
label in outline text (confirmed by the
OUTLINE indicator in the display).
Press shift and outline again to cancel and
return to normal text.
LABEL LENGTH
+
SIZE
LENGTH
Displays the current label length. The length is
normally calculated automatically, according to
the length of the text on the label.
• Press
DEL
to exit the length function without
changing the length, or:
• use
or
to increase (up to 402mm
max.) or decrease the length in 2mm steps.
The display will flash if you try to make the
label shorter than the text.
• If the length displayed is preceded by the
>
symbol, the length has already been fixed; the
label is too short for the text and it will not
print. Either press
to increase the length
in 2mm steps until the
>
symbol disappears,
or press
+
DEL
CLEAR
to cancel fixed length;
the label is now long enough for the text and
can be printed.
• Press
to fix the length for all subsequent
labels, confirmed by the
LENGTH SET
indicator in
the display, or
• press
to fix the new length and print the
label.
• Pressing
+
DEL
CLEAR
will cancel the fixed
length and restore the automatic length.
OUTLINE
ITALIC