Chicago Electric 66910 - Manual (Page 10)

Page 10 For technical questions, please call 1-800-444-3353. SKU 66910
Product Features
POWER
SWItCH
(42)
CIRCuIt
BREaKER
(39)
FEED
StICK
(76)
FIguRE D
HOPPER
(1)
POWER
CORD
(37)
tIE-DOWn
KnOBS
(11)
CHutE
(67)
FIguRE E
MaIn
HOuSIng
(14)
OPERatIng InStRuCtIOnS
Read the EntIRE IMPORtant
SaFEty InFORMatIOn section at
the beginning of this manual
including all text under
subheadings therein before set up
or use of this product.
Before operating, put on ANSI-approved
1.
safety glasses under an ANSI-approved
full face shield. Also wear heavy duty
work gloves and NIOSH-approved dust
mask/respirator.
If an extension cord is used, ensure that 2.
it is an outdoor type extension cord and
that it is the correct design to accept this
appliance’s plug.
WaRnIng! tO PREVEnt
ElECtRIC SHOCK anD
SERIOuS PERSOnal
InJuRy: the extension cord
must remain secured to the Chipper
Shredder’s plug. Secure the extension
cord by either using the knot method
explained in the safety warning section,
or by using a device designed
specifically for retaining the extension
cord (sold separately).
Position the Chipper Shredder on a flat,
3.
level, dry ground surface. Position the
machine so that the Chute (67) is pointed
in a safe direction, at least 25 feet from
any people, animals, or objects. Then,
chock both Wheels (29) of the machine
with scrap branches or rocks to keep the
unit from rolling. (See Figure E.)
Check to make sure the two Knobs (11) 4.
are firmly tightened. The vibration of
the unit during normal use will cause
the Knobs to loosen and allow the Main
Housing (14) to lift up off the Safety
Shut-Off Switch (55), turning off the
Motor (47) for safety. Tightening the
Knobs firmly will engage the Safety Shut-
Off Switch and allow the unit to start and
run. While the machine is running,
periodically check the tension of tie-
Down Knobs. (See Figure E.)
Insert the yellow Safety Lock-Off Switch 5.
into the Power Switch (42). Then turn
the Power Switch to its “On” position.
(See Figure D.)
Allow the Blades (20) to spin up to full
6.
speed.
IMPORTANT: Branches cannot be more
7.
than 1-1/4” in diameter. Never attempt
to cut limbs over 1-1/4” in diameter.
Doing so can cause equipment damage
and/or serious personal injury.