Monarch Instrument POCKET-TACH 100 - Manual (Page 2)

WARNINGS
Do not use this instrument in any manner incon-
sistent with these operating instructions or un-
der any conditions that exceed the environmen-
tal specifications stated.
Making measurements in direct contact with ro-
tating equipment can be dangerous. Keep all
loose clothing and hair away from exposed mov-
ing machinery. Keep the hand holding the in-
strument well behind the back end of the Con-
tact Tip Assembly.
Do not use this instrument for contact measure-
ments that exceed 20,000 RPM or 20,000 IPM.
Properly replace all machinery guards after com-
pleting measurement.
For technical assistance, contact the sales organization from which you
purchased the product. If they cannot assist you, they will refer you to
the manufacturer.
DECLARATION OF CONFORMITY
Low Voltage Directive:
IEC 1010-1 (EN 61010-1) Safety Requirements for Electrical
Equipment for Measurement, Control, and
Laboratory Use.
As Manufacturer:
Monarch Instrument
Division of Monarch International Inc.
15 Columbia Drive, Amherst NH 03031 USA
declares under Monarch’s sole responsibility that the product:
to which this declaration relates is in conformity with the following standards:
and therefore conforms with the requirements of Council Directive 73/23/EEC and
93/68/EEC relating to the low voltage directive with amendments.
Product: Hand Held Tachometer
Model:
POCKET-TACH 100
1 st March 1997
Manufacturer (Amherst,NH) Alan Woolfson, VP Engineering (Authorized Signature)