Monarch Instrument Track-It USB Loggers with Display - Manual (Page 2)

Rev: 0.92 06/22/11
Analog Input:
Most Track-It
TM
Data Loggers have the ability to measure up to 2 channels of analog inputs (4-20mA, 0-5Vdc etc) using external
analog modules that plug onto the USB connector. These may be purchased from your dealer and are programmed using the Track-It
TM
PC Software.
NOTE: Analog recordings are made via the USB connector. If possible (button programmed) STOP RECORDING before plugging the
recorder into the PC so as not to record the USB signals, otherwise use the Track-It
TM
Software "Stop Recording" button under the
Device Setup tab as soon as the device is plugged into the PC.
Protection:
The data Logger comes with a rubber boot that can be installed to
protect the USB connector and provide some degree of bump and
splash protection. The unit should have the boot installed when
traveling. The button can be operated when the boot is in place. The
boot cannot be fitted when analog modules are attached. The unit
should not be immersed in liquid.
Track-It
TM
PC Software:
The Track-It TM PC Software allows the Data Logger to be programmed, allows the data to be retrieved, displayed, saved to disk or
exported to Excel TM . Data can also be displayed in real time (on devices using internal sensors). The software has both simple and
advanced modes for programming the Data Logger. Some of the features are:
• Delayed recordings, fixed duration recordings by time or number of samples, multiple record times, manual record by button
press, record on alarms.
•
Sample rates from 2 seconds to 24 hours. Instantaneous, average, maximum or minimum values.
•
Two Alarms, high or low, latched or momentary and record under these alarm conditions
•
Input scaling and offset for analog modules. Engineering unit selection for internal sensors.
•
Button functions, LED functions and LCD display functions.
•
Display of data graphically, digitally or tabular formats with alarm indication.
•
Export user selected data in Excel
TM
or CSV formats. Filter data to be exported.
•
Simple setup (single screen) or advanced mode.
Replacing the Battery
To replace the battery - loosen the two screws on the back of the Logger and remove the bottom case half. Caution - the screws have
small plastic washers. There are two battery options. Replace the relevant battery then replace the cover and the screws.
Option 1 - Coin Cell CR2032 3.0V Option 2 - Lithium Thionyl Chloride EF651625 3.6V (LTC-7PN)