Monarch Instrument Track-It Pressure Temperature Logger - Manual (Page 2)

Rev: 0.93 05/30/13
The table below summarizes the push-button / LED functionality.
Serial Communication: The logger has a mini USB port. Plug the cable into this port and the other end into
the USB port on your PC/Laptop. The provided software needs to be installed in order to work with the logger.
Battery: Replace the battery as needed with type: ER14250 3.6V Lithium - Tadiran TL-5902 or similar.
Remove threaded cap and insert battery as shown in diagram below (observe polarity):
STATUS
LED Sequence
Low battery - one
RED blink (No red if battery OK)
Recording or triggered to record - fast GREEN / RED blink
Idle/Not recording - one long GREEN blink
Alarm occurred - one long RED blink (No red if no alarm)
Not set up or memory full - slow RED / GREEN blink, connect to PC
RESULT OF BUTTON RELEASE
LED pattern
Release button while LED
GREEN - Turn record mode on/off*
Release button while LED
RED - Reset alarm indication*
Release button when LED goes off - No change
*NOTE: Feature must be enabled in software
STATUS—Press & Release Button
LED Pattern
LED Pattern
Lo Batt. >>>> Record >>>>> Alarm
CHANGE STATE—Press & Hold Button
Release
Release
Release after LED’s go off