Classe Audio SSP-30 MKII - Manual (Page 26)

6.2 RECORDING ANALOG AUDIO ONLY
Setup for recording Audio to a non-digital two channel tape machine is described below. When the
primary source is digital, you must be sure you connect the analog output from the digital source to
the same SOURCE the digital audio is assigned to.
6.2.1 SSP B TAPE. Use a two channel analog audio cable to connect the analog RECORD OUT of the SSP-30
MKII to the record input of the Tape Machine or other analog recording component.
6.2.2 TAPE B SSP. Use a two channel analog audio cable to connect the analog output from your Tape Machine to
any analog audio only Input. (AUDIO 1 through AUDIO 5, unless you want to use the balanced input of
AUDIO 6)
6.2.2.1 Follow the usual recording component instructions for recording.
6.3 RECORDING DIGITAL AUDIO/VIDEO
Setup for recording a digital audio signal plus Video to a digital Audio/Video recording device is
described below.
There is one digital audio output. The information available is the same data as input to the currently
accessed digital audio input. If you are watching a Movie from a DVD player and wish to record it for
future viewing you can use a digital VCR or other digital recording component.
6.3.1 SSP B D-VCR. Use a digital TOSlink cable to connect the output from the SSP-30 MKII’s digital Output to the
digital input of the digital recording component.
6.3.2 SSP B D-VCR Use an S-Video or Composite Video cable to connect the REC S-Video or Composite Video
output of the SSP-30 MKII to the S-Video or Composite video input of the recording component.
OR :
6.3.3 SSP B D-VCR Use an S-Video or Composite Video cable to connect the free S-Video or Composite Video
Monitor output of the SSP-30 MKII to the S-Video or Composite video input of the recording component. This
is a useful workaround if you are using the REC video output to feed an analog VCR.
6.3.4 D-VCR B SSP. Use a digital Coaxial or TOSlink cable to connect the digital output of the of the digital
recording component to any available digital inputs (COAX 1 through COAX 4, or TOSlink 1or TOSlink 2 or
AES/EBU).
6.3.5 D-VCR B SSP. Use an S-Video or Composite Video cable to connect the video out of the DVD player or
Satellite receiver, etc. , that you wish to record, to the same SOURCE the digital input is assigned to, and to
which the analog audio is connected. (S-Video will convert to Composite, but not vice-versa). Do not connect
to REC.
6.3.5.1 Follow the usual recording component instructions for recording. The digital output of the SSP-30 MKII’s
DIGITAL OUT always follows the input on the SOURCEs AV 1 through AUDIO 4.
26