5317-5323 wing transport, Center lift & gang mount, 5317-5323 wing transport center lift & gang mount – Great Plains TC5319 Assembly Manual User Manual

Page 12

Advertising
background image

8

TC5109-5323

Table of Contents

Index

Great Plains Manufacturing, Inc.

566-046E

Table of Contents

Index

04/12/2012

5317-5323 Wing Transport

Refer to Figure 7
22. Once the wing Frame has been uncrated, carefully

turn the wing frame upside down and set on blocks to
assemble torque tube.

23. Carefully raise the torque tube

with an overhead

hoist and secure with 1 1/4 x 7 pins

, 3/8 x 2 1/4 Gr.

8 hex bolts

and 3/8 top lock nut.

24. Install pre-assembled 8-bolt hub assemblies

into

torque tube

. Align holes in spindle with hole in

torque tube, secure with 5/16 x 3 1/2 Gr. 8 hex bolt
and 5/16 top lock nut.

25. Attach the tire/wheel assembly

to hub assembly

and secure with 5/8 lug nuts

.

26. All bolts may be tightened to specs, See “Torque

Values Chart” on page 27.

Note: Fasten the bottom of the torque tube to frame with

chain or straps so it does not swing down and hit
something while turning center frame over. Careful-
ly use hoist to turn center frame over and set on
stands to finish assembling components.

Center Lift & Gang Mount

Refer to Figure 8
27. Attach the cylinder mount bars

and lift link

to

center frame using 1 x 3 1/2 hex bolts

, 1 x 4 hex

bolts

and 1 lock nuts.

28. Now install 4.5 x 10 cylinders

using 1 x 3 1/8 pins

, 1.5 x 1.0 x.075 machine washers and 3/16 x 2

cotter pins.

29. Install cylinder transport locks

to lift link

using

the 5/16 wire retainer pin

.

30. On models 5111-5115 fasten wings

to center

frame with 3/4 x 2 1/2 hex bolts

, 3/4 lock washers

and 3/4 nuts.

Note: Wing shank mounts

are only used on a few mod-

els, see machine and attachment layout drawings in
Appendix for proper placement.

31. Attach outside wing shank mounts

(if equipped)

with 3/4 x 2 1/2 hex bolts

3/4 lock washers and 3/

4 nuts.

32. Attach center gang mount

and wing gang mounts

to front of center frame and wing frame with 3/4 x

2 hex bolts

, 3/4 lock washers and 3/4 nuts.

33. All bolts may be tightened to specs, See “Torque

Values Chart” on page 27.

Figure 7

5317-5323 Wing Transport

42626

5

2

3

1

U

D

F

B

L

R

6

4

7

1

2

3

4

1

5

6

4

7

1

2

3

4

5

6

7

2

8

9

10

11

11

10

12

13

14

Advertising