Great Plains 3S-4000HDF Predelivery Manual - Manual (Page 28)

26 3S-4000HD
195-067Q 12/10/2009
Align Transfer Drive Shaft
Refer to Figure 32 and Figure 33
After wing boxes are properly aligned, the transfer drive
shaft must be aligned so the pair of break-away jaws
are fully engaged and are concentric. The
7 ⁄
8
in hex drive
shafts holding the clutch jaws should not contact each
other
when wing boxes are properly aligned and back
against their stops.
1. Place a 4x4in (10x10cm) or similar sized block ahead
of the wing gauge wheels and pull forward or push
wing box frames back until the tool bar is firmly
against tool bar stop bolts on the center box frame.
2. To align the clutch jaws vertically, loosen the two
5 ⁄
8
inch bolts on the backside of the adjustment
plate . Slide the plate up or down in the desired
direction. Tighten bolts.
Figure 32
Transfer Drive Jaws
18955
1
2
Figure 33
Transfer Drive Shaft Vertical Adjustment
18953
4
3
4
1
1
2
3
4