Great Plains NP3000A Predelivery Manual - Manual (Page 25)

Great Plains Manufacturing, Inc. Table of Contents Index Install Components 21
03/31/2011 Table of Contents Index 407-613Q
Install Wing Gauge Wheels
If all the gauge wheels are already installed, continue at
topic “Install Nurse Tank Hitch” on page 22.
Install Manual Gauge Wheels
If not installed for shipment, these assemblies may be
fully dismounted at the tool bar, or may have only the
wheels removed. If only the wheels need to be installed,
continue at topic “Install 2P Wheels” on page 21.
2P Gauge Wheel Stations
Before installing, determine the location for each gauge
wheel, which varies by row count.
Gauge wheels mount at row center-lines.
Install 2P Gauge Wheel Mounts
Refer to Figure 29
1.
Select two:
407-321S 3PT GW ASSEMBLY
and four:
806-016C U-BOLT 5/8-11 X 6 1/32 X 5 3/4
and eight sets:
803-021C NUT HEX 5/8-11 PLT
804-022C WASHER LOCK SPRING 5/8 PLT
2. Secure the mounts at the gauge wheel stations from
the table above.
Install 2P Wheels
Refer to Figure 30
1.
Locate two:
596-065K TIRE 20.5 X 8 10 PLY 6 BOLT
with hub assemblies installed.
2. Remove and save at each wheel, two sets:
802-064C HHCS 3/4-10X2 GR5
804-023C WASHER LOCK SPRING 3/4 PLT
3. Install the wheel assemblies at each gauge wheel
arm
.
Implement
Model
Gauge Wheel Station
RH LH
NP3000-1230 Row 12 Row 1
NP3000-1230SD Row 2
a
a. Note that if the wing extension was not installed for
shipment (the usual case), the first row is not
present (illustrated in gray). The first present row
on the LH wing is Row 2 and not Row 1.
Row 13
a
Figure 28
Gauge Wheel Stations
32043
7 6 5 4 3 2 1
NP3000-1230
Figure 29
Gauge Wheel Assembly
31706
47
20
44
38
Figure 30
2P Gauge Wheel
31706
45
2
32
19
20
47
38
44
2
32
45
19