Great Plains 6328 Series VII Field Cultivator-Rigid Hitch Operator Manual - Manual (Page 24)

Section 1: Assembly
Table of Contents ► Great Plains Mfg., Inc..
Series VII 6113-6328 Field Cultivator, Rigid Hitch 560-202M 9/18/2003
22
Center Wing Stop / Rear Jack Stand Assembly
U-bolt the center wing stop (1) to the
second bar from the rear on the center frame as
shown in Figure 9. Use 1/2 x 3 x 5 u-bolts (2)
with lock washers and hex nuts. Center the
wing stop from side to side. Insert the 1/2 x 4
1/2 transport lock quick pins (3) in the holders
on the wing stop.
Insert the rear stand leg (4) into the
frame mount bracket (5) as shown in Figure 9.
Pin them together using the 3/4 x 4 1/2 pin
w/kepper (6). U-bolt the whole assembly to the
rear bar of the center frame using two 5/8 x 4
1/32 x 4 1/4 u-bolts (7) using lock washers and
hex nuts. Final placement of jack stand should
not interfere with shanks or finishing
attachment arms.
Figure 9