Compatible Systems IntraPort A00-1869 - Manual (Page 15)

Chapter 2 - Mounting Instructions 9
Right Bracket Installation
Figure 4. Fastening the Right Bracket to the Rack
1. It is recommended that you mark on the equipment rack exactly where you want the
top of the two mounting brackets to go on the device in order to make sure that they
are level with each other (using a level if necessary). Once you have determined the
desired location, fasten the right bracket to the rack using your own screws or clips, as
shown in Figure 4.
• At least 2 screws must be used to fasten the top of the bracket to the rack (using
any two holes on the rack tab).
• At least 3 screws must be used to fasten the bottom of the bracket to the rack.
One of the screws must be used to fasten the very bottom hole in the rack tab.