Chapter 8 - led patterns and test switch settings, Intraport enterprise-8 led patterns, Over temp – Compatible Systems IntraPort A00-1869 User Manual
Page 36: Sys ready, General indicators, Ethernet traffic indicators, Load % indicators, Ntra, Nterprise, 8 led p
Chapter 8 - LED Patterns and Test Switch Settings
30
Chapter 8 - LED Patterns and Test Switch Settings
IntraPort Enterprise-8 LED Patterns
The IntraPort Enterprise-8 VPN Access Server uses a number of light patterns on its front LED
bars to indicate operating conditions.
v Note: Any continuous flashing pattern not noted in this chapter may be caused by a hard-
ware failure. Please call Compatible Systems’ Technical Support if your server shows a hard-
ware failure.
Over Temp
The server is above the proper operating temperature. The filter needs changing. See
Appendix E for instructions.
Sys Ready
The server booted properly without detecting any failures.
General Indicators
Ethernet Traffic Indicators
TX: Ethernet transmit packet
RX: Ethernet receive packet
Load % Indicators
These lights indicate the load on the encryption coprocessor card.
Ethernet Lights
Load Lights
Indication
5 flashing
20 flashing
Server stacks starting up.
3&4 flashing
40&60 flashing
No OS loaded. Running from ROM.
1&4
flashing
40&100
flashing
Erasing OS in Flash ROM.
5
flashing
20,40&60
flashing
Erasing config in Flash ROM.
Scanning from the outside toward the center
Flash ROM erase due to switch setting five or six is
complete. Set switch to zero and cycle power.