AEO Photo Micro MT Pro 3.0 - Manual (Page 2)

AEOPhoto Page 2 of 3 Revision:7-May-12
8. Turn the lightning trigger device power on FIRST before you power up the camera. (When the
trigger is first tuned on, it will trigger once on power up . . . not a big deal for digital
photography, but if you use film, you’ll lose one frame.)
9. Avoid using your cell phone near the device while it’s operating. Your lightning shutter trigger is
a sensitive device and can be triggered inadvertently by strong, nearby RF transmissions.
10. Grab your favorite refreshing beverage and wait for the show to start!
Motion Mode:
Your AEO MultiTrigger Pro is equipped with a passive PIR 10 meter motion detector. Motion is detected
via changes in the Infrared within the field of view of the device. The spectrum of the detector is in the
LWIR, meaning that it will only detect movement of IR sources that generate heat, such as an animal or
a human. Since LWIR is NOT transmissive through materials such as glass and acrylic, your trigger will
NOT sense motion through a window. At the sensors limits of 10 meters, larger object such as humans,
deer and bear should be detectable. Up closer, the sensor will detect movement of smaller objects. The
field of view is approximately 35 degrees, so you may need to position the sensor carefully so as to
detect motion in the area you wish to photograph.
The Hot Shoe mount on your trigger also includes a standard ¼-20 female thread for mounting on a
tripod. This free’s up your hot shoe for other accessories such as a flash.
To operate in “Motion Detection Mode”, simply place the Mode Switch in the “Motion” Position. To
test your device, connect your camera as outlined previously in the “Lightning Detection” Mode. Wave
your hand in front of the detector to ensure it triggers properly. Experiment with walking in front of the
trigger to establish your effective field of view at various distances.
Battery Replacement:
Your LS Micro is designed to accept a variety of ½ AA batteries available where most batteries are sold.
The first set of batteries is included.
Types of batteries:
Lithium 3.6 volt ½ AA – designed for longer life
Alkaline camera batteries, such as Energizer A544 6 volt ½ AA or compatible.
If you have questions, or if you wouldn’t mind sending us some of your photographs, contact us at
[email protected] or by mail at 1435 Tally Ho Lane, Norco, CA 92860
Front of Micro Trigger
• Slide battery case open.
• Batteries may pop out.
• When done replacing new batteries
be sure cover in aligned properly
and gently slide back into place.
• +/- are printed on the bottom of the
battery compartment.