AEO Photo Micro Pro 4.0 - Manual (Page 2)

8. Turn the lightning trigger device power on FIRST before you power up the camera. (When the
trigger is first tuned on, it will trigger once on power up . . . not a big deal for digital photography,
but if you use film, you’ll lose one frame.)
9. Avoid using your cell phone near the device while it’s operating. Your lightning shutter trigger is
a sensitive device and can be triggered inadvertently by strong, nearby RF transmissions.
IMPORTANT BATTERY INFORMATION: The LS 4.0 Lithium Series Triggers are designed to operate with a
single Li-Ion 14500 3.7V rechargeable battery ONLY. Using any other type of battery may cause damage
to the charging system (PRO Models) and the battery itself.
In accordance with postal regulations regarding the shipment of Li-Ion batteries, your AEO LS 4.0 Trigger
is shipped with a partially depleted rechargeable Li-Ion 14500 battery. Before using your device, ensure
the battery has been completely charged. Once charged, the device is designed to operate for over 180
hours continuously on a single charge.
Pro Models are equipped with a built in Li-Ion battery charger that derives power from any USB source
via a Micro-B USB connector on the RIGHT side of the device. When powered via USB, the USB LED
indicator is ORANGE during a charge cycle, GREEN when the charge cycle is complete. Additionally, the
unit can be operated while USB power is connected, even if there is no battery present or the battery is
completely depleted.
INSTALLING NEW BATTERY: AEO RECOMMENDS THAT YOU NEVER OPEN THE BATTERY
COMPARTMENT ON OUR PRO MODELS. THE BUILT-IN CHARGER NEGATES THE NEED TO REMOVE THE
CELL FOR CHARGING. IF THE CELL IS REMOVED AND RE-INSERTED REVERSE POLARITY, THE DEVICE
WILL BE DAMAGED AND NOT COVERED BY WARRANTY.
IF YOU BELIEVE THE BATTERY HAS BECOME DAMAGED OR IS NO LONGER CHARGEABLE, YOU CAN SEND
YOUR UNIT BACK TO AEO FOR BATTERY REPLACEMENT, OR YOU CAN ATTEMPT TO CHANGE THE
BATTERY YOURSELF, BY FOLLOWING THE INSTRUCTIONS BELOW, MAKING SURE THAT THE POLARITY IS
CORRECT BEFORE PLUGGING IN A USB POWER SOURCE.
INSTALLING NEW BATTERY: The Li-Ion 14500 battery is accessible via a slide out battery compartment
cover on the bottom of the device as shown below:
Take note of the polarity of the battery, and ensure that the replacement battery is inserted correctly.
POSITIVE POLARITY SIDE NEGATIVE POLARITY SIDE