Amico Surface Mount Console Unit - Manual (Page 4)

3. Remove any aluminum device covers that are blocking access to the back plate. This is done by loosening
the screws (typically 2 per cover) attaching it to the console box. Place everything in a safe and clean
location.
4. Secure the console to the wall structure. Use existing holes if it matches the stud locations or drill new
mounting holes as necessary (pictured above). Minimum two mounting locations should be used.
5. Make all necessary electrical medical gas connections.
6. After connections are made, reassemble console in the reverse order as shown in the steps outlined
above.
BACK PLATE
EXISTING
MOUNTING
HOLES
4 Amico Pipeline