Aphex USB 500 Rack - Manual (Page 5)

You should now see signal on the input and output meters and hear yourself in
the USB 500 Rack headphones or speakers.
Steinberg Cubase
Launching Cubase will bring up the Steinberg Hub.
Under Projects, select Empty.
Use the default location, name your new project and click Create.
Go to Devices-Device Setup.
Under VST Audio System, select USB 500 RACK from the drop down menu.
You will be prompted, “Do you want to switch driver?” Click Switch.
Set Audio Priority to Boost.
Click Apply, then click OK.
Go to Devices-Device Setup again.
In the left column of Devices, click on Aphex USB 500 RACK.
In the new window on the right, click on Control Panel.
Set the Buffer Size to 64 Samples. (If you hear pops and clicks in your audio,
come back and set the I/O Buffer Size to 128. Set this as low as possible without
hearing pops and clicks.)
Click Close, then click OK on the bottom right.
Go to Devices-VST Connections.
Under Inputs, click Add Bus.
Select 1, mono and click Add Bus. You will now see Mono In, Audio Device USB
500 RACK, Device Port USB 500 RACK Analog 1.
Click the Outputs tab.
You should see Stereo Out, Audio Device USB 500 RACK, Device Port USB 500
RACK Analog 1 and USB 500 RACK Analog 2.
Go to Project-Add Track-Audio. Leave the default settings and click Add Track.
Click the red circle (Track Arm) on your track.
Click on the Speaker icon.