Apricorn Aegis Bio 3.0 - Solid State Drive - Manual (Page 4)

Enrolling a new finger
If there are less than 5 fingerprints enrolled and you want to enroll a new finger,
follow the instructions below.
1. Plug in the Aegis Bio to a USB port on your computer. The LED should
be Solid RED indicating that the drive is Standby mode.
2. Push the ENROLL button for 3 seconds.
If less than 5 fingerprints are enrolled, the BLUE LED will become Solid
BLUE and RED LED will remain illuminated. Proceed to Step 3.
If 5 fingerprints are enrolled, the BLUE and GREEN LED will come on for 2
seconds and the RED LED will be Solid RED . You will not be able to enroll
any more fingerprints.
3. Swipe a finger that has been previously enrolled. The GREEN LED will
flash if the fingerprint is accepted. If the fingerprint is not accepted the RED
LED will flash.
4. Once the fingerprint is accepted the BLUE LED will become Solid BLUE and
the GREEN LED will continue flashing, indicating that the Aegis Bio is ready
to enroll a new fingerprint.
5. Swipe a new finger. The BLUE LED will turn off while the GREEN LED
starts to flicker briefly as the Aegis Bio processes your new fingerprint.
Wait until the BLUE LED turns back to Solid BLUE and the GREEN LED
returns to its flashing state.
6. Repeat Step 5 until both the BLUE and GREEN LED are in a solid state,
indicating that your fingerprint is fully enrolled.
NOTE: Once enrolled, fingerprints cannot be un-enrolled individually. To
remove enrolled fingerprints, a complete re-set of the drive is required.
Apricorn provides the following helpful resources for you:
1. Apricorn’s Website ( http://www.apricorn.com)
This gives you the ability to check for up-to-date information
2. E-mail us at [email protected]
3. Or call the Technical Support Department at 1-800-458-5448
Apricorn’s Technical Support Specialists are available from 8:00 a.m. to
5:00 p.m., Pacific Standard Time Monday through Friday
Technical Support