Apricorn Aegis Padlock Pro - Solid State Drive - Manual (Page 13)

www.apricorn.com 13
You can add a new User Password by doing the following:
1. Enter the Admin Mode (refer to page 11 for details).
2. Press and hold + 1 until the indicator light flashes blue intermittently.
3. Enter a User Password and press (a minimum of 6 digits and a maximum
of 16 digits) The indicator light flashes green three times.
4. Re-enter the new User Password and press . If the indicator light stays
solid green for two seconds and then solid blue, the User Password was
added successfully.
Adding a new User Password
Deleting the User Passwords
You can delete all User Passwords by doing the following:
1. Enter the Admin Mode (refer to page 11 for details).
2. Press and hold 7 + 8 + for five seconds until the indicator light flashes blue
intermittently. After the indicator light flashes green three times and then blue
intermittently.
3. Press and hold 7 + 8 + a second time for five seconds until the indicator
light goes on solid green for two seconds and then back to solid blue, this
indicates that the User Passwords were deleted successfully.
Changing the User Password
You can change the User Password by doing the following:
1. Enter User Mode (refer to page 10 for details).
2. Press and hold + 1 until the indicator light flashes red.
3. Enter your old password and press . The indicator light will turn green,
then change to flashing blue.
4. Enter the new password and press (The Password must be a minimum of
6 digits and a maximum of 16 digits). The indicator light will flash green three
times.
5. Re-enter the new User Password and press . The indicator light stays solid
green indicating the User Password has been changed successfully.